Install either the kismet or kismet_drone package. Then edit /etc/kismet_drone.conf and change the source from wrt54g,eth1,wrt45g to wrt54g,prism0,wrt54g.
Then run kismet from your host, pc and off u go!
Thursday, July 14, 2005
Monday, July 04, 2005
a few tips with olsr on openwrt freifunk
I had this problem with the OLSR web interface on the Freifunk openwrt implementation. If entered the following for the HNA4 field
HNA4: 10.3.13.1 255.255.255.0
Which should advertise the whole 10.3.13.x net it would advertise the 10.0.0.0 net. I discovered that it needs the subnet mask in this format instead
HNA4: 10.3.13.1/24
A few other things I learnt
1. NVRAM variable ff_hna4 stores the HNA4 setting
2. /etc/olsr.conf is ignored by freifunk
3. /rom/etc/olsrd.conf stores a permanent copy of the olsrd setup
4. /var/etc/olsrd.conf is a symbolic link to /tmp/etc/olsrd.conf ... this file is copied from /rom/etc/olsrd.conf into RAM (ramfs filesystem) and is the one called by olsrd.
ps -A will reveal that olsrd is called as follows
olsrd -f /var/etc/olsrd.conf -d 0
HNA4: 10.3.13.1 255.255.255.0
Which should advertise the whole 10.3.13.x net it would advertise the 10.0.0.0 net. I discovered that it needs the subnet mask in this format instead
HNA4: 10.3.13.1/24
A few other things I learnt
1. NVRAM variable ff_hna4 stores the HNA4 setting
2. /etc/olsr.conf is ignored by freifunk
3. /rom/etc/olsrd.conf stores a permanent copy of the olsrd setup
4. /var/etc/olsrd.conf is a symbolic link to /tmp/etc/olsrd.conf ... this file is copied from /rom/etc/olsrd.conf into RAM (ramfs filesystem) and is the one called by olsrd.
ps -A will reveal that olsrd is called as follows
olsrd -f /var/etc/olsrd.conf -d 0
Subscribe to:
Posts (Atom)